Initial Inspection of the Suspension

In that I was planning to replace the stock Dodge front suspension with a front end clip from a GM chassis, I needed to do a 1st pass inspection of the front and rear suspension.
Inspecting the Running Gear

Once I had a chance to look everything over, I took some initial measurements to determine ride height and other basic suspension setup parameters.
Checking Ride Height

This proceedure pointed out to me that due to the slope on my shop floor that I would have some measurement issues when I get around to cutting off the old suspension and grafting on a new one from a GM chassis.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.