I had originally planned on using a GM G Body (midsize – metric) as the donor for the front suspension. The 1st problem I ran across was that these cars were being eaten up at an alarming rate by the … Continue reading
Category Archives: Front Suspenion
Because of the 1/4″ per foot slope in my shop floor I could not use the floor as my baseline marker to get various frame heights and angles. I went over to Lowes and bought a fairly inexpensive laser level. … Continue reading
In that I was planning to replace the stock Dodge front suspension with a front end clip from a GM chassis, I needed to do a 1st pass inspection of the front and rear suspension. Inspecting the Running Gear Once … Continue reading